Futaba 6EXAP 6-Channel FM 40MHz/ R136F 富他巴  [6EXAP_c2]

FEATURES:

• Aileron, Elevator and Rudder twin rate switch - Use this switch to flip between two aileron, elevator and rudder control throw settings. The throws are create you prefer, but generally speaking, when the switch is up the throws are greater (higher rate) and when the switch is down the throws are less (low rate). This switch additionally flips between exponential prices (if utilized).
• Flap control dial/Channel 6 - This dial operates the servo connected to channel 6 in the receiver should your model has flaps this is actually the control used to use them.Aileron/elevator control stick -Mounting point for optional neck strap.
• Trim levers (all) -Used to move the basic or center position of every servo as labeled into the diagram.
• Billing jack - Port for billing the transmitter batteries with the included battery pack charger.
• On-off switch
• DATA INPUT lever - accustomed change the values regarding the various functions displayed in the LCD display.
• Liquid-crystal display (LCD) - shows programming modes and values entered.
• MODE key - Used to scroll through and show the ten or eleven(PCM) various functions.
• PICK key - always display the values for the present function.
• Throttle-cut switch - to utilize the throttle-cut function, lower the throttle stick completely, then Push the throttle-cut button to totally close the carburetor and shut of motor.
• Throttle/rudder control stick - runs the servos linked to channel 3 (throttle) and channel 4 (rudder) inside receiver.
• Trainer switch - runs the trainer functions. To use as a trainer switch the transmitter should be linked to another transmitter via. a trainer cord (available individually).
• Retractable landing gear switch/Channel 5 - Switch runs the servo linked to channel 5 in the receiver when your model has retractable landing gear this is the control accustomed extend and retract the gear.
• Antenna - Radiates signals to your receiver. Never ever fly a model without completely expanding the antenna or you may produce disturbance to other modelers and decrease operational sign range of the
• transmitter. The antenna may be removed and changed with another just in case it is inadvertently broken.

INCLUDES:

• Futaba 6-Channel 6EXAP transmitter
• Futaba R136F Receiver
• Change Harness
• Manual

SPECS:

Transmitter

• T6EXAP Transmitter with programmable mixing and 6-model memory.
• Transmitting on 40 / 72 MHz musical organization.
• Operating system: 2-stick, 6-channel system
• Modulation: FM(PPM) and PCM
• Power supply: 9.6V NT8S600B Ni-Cd battery pack or 12V alkaline battery pack
• Current drain: 250mA

Receiver

• R136F narrow band, FM 6 channel receiver.
• Receiving on 40 / 72 MHz band.
• Type: FM, Dual conversion/FM, Single transformation
• Intermediate frequencies: 455kHz, 10.7MHz/455kHz
• Energy requirement: 4.8V or 6V
• Present drain: 9.5mA @ 4.8V
• Size: 1.31 x 1.98 x 0.71" (33.4 x 50.3 x 18.1mm)
• Fat 0.98oz (27.8g)