Futaba 6EXAP 6-Channel FM 40MHz/ R156F 富他巴 [6EXAP_c3]

價格:

HKD$894.96

牌子:

Futaba

型號:

6EXAP_c3

售罄

請輸入姓名和電子郵件地址。當貨品重新上架我們將笫一時間通知閣下.

你或可於 R/C Models - System - Transmitter - Flight Transmitters
類別中嘗試尋找類似的產品

填寫評論

產品說明

QUALITIES:

Aileron, Elevator and Rudder double rate switch - utilize this switch to flip between two aileron, elevator and rudder control throw settings. The tosses could be put up nevertheless you choose, but generally speaking, when the switch is up the throws are greater (higher rate) so when the switch is down the throws are less (low rate). This switch also flips between exponential prices (if used).
Flap control dial/Channel 6 - This dial operates the servo linked to channel 6 within the receiver in case your model has flaps here is the control used to operate them.Aileron/elevator control stick -Mounting point for optional neck band.
Trim levers (all) -Used to move the basic or center place of every servo as labeled within the diagram.
Billing jack - Port for charging the transmitter batteries with all the included battery pack charger.
On-off switch
INFORMATION INPUT lever - always replace the values of the various functions exhibited on the LCD screen.
Liquid-crystal display (LCD) - shows programming modes and values joined.
MODE key - always scroll through and show the ten or eleven(PCM) different functions.
CHOOSE key - always display the values the current function.
Throttle-cut switch - to utilize the throttle-cut function, lower the throttle stick all the way, then drive the throttle-cut switch to fully shut the carburetor and shut of the motor.
Throttle/rudder control stick - Operates the servos attached to channel 3 (throttle) and channel 4 (rudder) in the receiver.
Trainer switch - runs the trainer functions. To use as a trainer switch the transmitter must be attached to another transmitter via. a trainer cord (available separately).
Retractable landing gear switch/Channel 5 - change operates the servo linked to channel 5 inside receiver should your model has retractable landing gear this is the control used to extend and retract the gear.
Antenna - Radiates signals to your receiver. Never travel a model without fully extending the antenna or you may create disturbance to other modelers and decrease functional signal array of the transmitter. The antenna might be removed and replaced with another just in case it's accidentally broken.

INCLUDES:
Futaba 6-Channel 6EXAP transmitter
Futaba R156F Receiver
Change Harness
Manual

SPECS:
Transmitter
T6EXAP Transmitter with programmable blending and 6-model memory.
Transmitting on 40 / 72 MHz band.
Operating-system: 2-stick, 6-channel system
Modulation: FM(PPM) and PCM
Power: 9.6V NT8S600B Ni-Cd battery pack or 12V alkaline battery
Present drain: 250mA

熱門品牌

Futaba 6EXAP 6-Channel FM 40MHz/ R156F 富他巴 [6EXAP_c3]