Futaba 6EXAP 6-Channel FM 72Mhz/ R136F/ 4xS3003 富他巴  [6EXAP_c6]

價格:
HKD$1,136.21
牌子:
Futaba
型號:
6EXAP_c6
請輸入姓名和電子郵件地址。當貨品重新上架我們將笫一時間通知閣下.
你或可於 R/C Models - System - Transmitter - Flight Transmitters
類別中嘗試尋找類似的產品
填寫評論
QUALITIES:
  • Aileron, Elevator and Rudder dual rate switch - utilize this change to ��flip�� between two aileron, elevator and rudder control throw settings. The tosses may be set up nevertheless you choose, but generally, whenever switch is ��up�� the throws are greater (��high rate��) so when the switch is ��down�� the throws are less (��low rate��). This switch also flips between exponential prices (if used).
  • Flap control dial/Channel 6 - This dial runs the servo attached to channel 6 in the receiver should your model has flaps this is actually the control used to use them.Aileron/elevator control stick -Mounting point for optional neck strap.
  • Trim levers (all) -Used to move the neutral or center place of each and every servo as labeled inside diagram.
  • Asking jack - Port for charging you the transmitter batteries using the included battery pack charger.
  • On-off switch
  • DATA INPUT lever - Used to replace the values of various functions exhibited regarding the LCD display.
  • Liquid-crystal display (LCD) - Displays programming modes and values entered.
  • MODE key - accustomed scroll through and show the ten or eleven(PCM) various functions.
  • SELECT key - regularly display the values for the present function.
  • Throttle-cut button - to make use of the throttle-cut function, lower the throttle stick entirely, then drive the throttle-cut button to completely close the carburetor and shut of this motor.
  • Throttle/rudder control stick - Operates the servos linked to channel 3 (throttle) and channel 4 (rudder) in receiver.
  • Trainer switch - runs the trainer functions. To operate as a trainer switch the transmitter needs to be connected to another transmitter via. a trainer cord (available separately).
  • Retractable landing gear switch/Channel 5 - Switch runs the servo linked to channel 5 in the receiver in case the model has retractable landing gear this is the control used to extend and retract the gear.
  • Antenna - Radiates signals to the receiver. Never travel a model without completely expanding the antenna or you may produce interference to many other modelers and decrease functional signal range of the transmitter. The antenna could be removed and replaced with another whenever it really is unintentionally broken.

Copyright © 2013-2024 rcjaz.com.hk 版權所有