Futaba 6EXAP 6-Channel PCM 40Mhz/ R136HP/ 4xS3003 富他巴 [6EXAP_c8]

價格:

HKD$1,470.84

牌子:

Futaba

型號:

6EXAP_c8

售罄

請輸入姓名和電子郵件地址。當貨品重新上架我們將笫一時間通知閣下.

你或可於 R/C Models - System - Transmitter - Flight Transmitters
類別中嘗試尋找類似的產品

填寫評論

產品說明

QUALITIES:

Aileron, Elevator and Rudder dual price switch - make use of this switch to ��flip�� between two aileron, elevator and rudder control throw settings. The throws may be setup nevertheless you choose, but generally, when the switch is ��up�� the throws are greater (��high rate��) and when the switch is ��down�� the throws are less (��low rate��). This switch additionally flips between exponential rates (if utilized).
Flap control dial/Channel 6 - This dial runs the servo linked to channel 6 within the receiver in case your model has flaps this is the control used to operate them.Aileron/elevator control stick -Mounting point for optional neck band.
Trim levers (all) -Used to move the neutral or center place of every servo as labeled into the diagram.
Recharging jack - Port for charging you the transmitter batteries aided by the included battery pack charger.
On-off switch
INFORMATION INPUT lever - regularly replace the values of the different functions exhibited regarding the LCD screen.
Liquid-crystal display (LCD) - Displays development modes and values entered.
MODE key - always scroll through and display the ten or eleven(PCM) various functions.
PICK key - accustomed display the values for the current function.
Throttle-cut key - to utilize the throttle-cut function, reduced the throttle stick completely, then drive the throttle-cut switch to fully shut the carburetor and shut of the motor.
Throttle/rudder control stick - runs the servos linked to channel 3 (throttle) and channel 4 (rudder) in receiver.
Trainer switch - Operates the trainer functions. To use as a trainer switch the transmitter must be attached to another transmitter via. a trainer cable (available separately).
Retractable landing gear switch/Channel 5 - change runs the servo linked to channel 5 inside receiver if your model has retractable landing gear this is actually the control accustomed extend and retract kit.
Antenna - Radiates signals to the receiver. Never ever travel a model without completely extending the antenna or perhaps you may create interference to many other modelers and decrease operational signal range of the transmitter. The antenna could be eliminated and replaced with another in case it is accidentally broken.

熱門品牌

Futaba 6EXAP 6-Channel PCM 40Mhz/ R136HP/ 4xS3003 富他巴 [6EXAP_c8]