Futaba 6EXAP 6-Channel PCM 72Mhz/ R136HP/ 4xS3003 富他巴 [6EXAP_c9]

價格:

HKD$1,470.84

牌子:

Futaba

型號:

6EXAP_c9

售罄

請輸入姓名和電子郵件地址。當貨品重新上架我們將笫一時間通知閣下.

你或可於 R/C Models - System - Transmitter - Flight Transmitters
類別中嘗試尋找類似的產品

填寫評論

產品說明

QUALITIES:

Aileron, Elevator and Rudder dual rate switch - utilize this switch to ��flip�� between two aileron, elevator and rudder control throw settings. The tosses can be create nevertheless you choose, but generally, as soon as the switch is ��up�� the throws are greater (��high rate��) when the switch is ��down�� the throws are less (��low rate��). This switch additionally flips between exponential rates (if used).
Flap control dial/Channel 6 - This dial runs the servo attached to channel 6 into the receiver if your model has flaps this is actually the control utilized to operate them.Aileron/elevator control stick -Mounting point for optional throat strap.
Trim levers (all) -Used to shift the neutral or center position of every servo as labeled into the diagram.
Billing jack - Port for asking the transmitter batteries with the included battery pack charger.
On-off switch
INFORMATION INPUT lever - regularly replace the values of this various functions presented on LCD screen.
Liquid-crystal screen (LCD) - Displays development modes and values entered.
MODE key - Used to scroll through and display the ten or eleven(PCM) various functions.
SELECT key - accustomed show the values for the present function.
Throttle-cut switch - to utilize the throttle-cut function, lower the throttle stick entirely, then Push the throttle-cut button to fully close the carburetor and shut associated with motor.
Throttle/rudder control stick - runs the servos linked to channel 3 (throttle) and channel 4 (rudder) into the receiver.
Trainer switch - Operates the trainer functions. To use as a trainer switch the transmitter should be linked to another transmitter via. a trainer cord (available separately).
Retractable landing gear switch/Channel 5 - change operates the servo attached to channel 5 within the receiver in case the model has retractable landing gear here is the control accustomed extend and retract kit.
Antenna - Radiates signals towards receiver. Never travel a model without fully extending the antenna or you may create disturbance to many other modelers and decrease functional signal range of the transmitter. The antenna are eliminated and replaced with another whenever it's inadvertently broken.

熱門品牌

Futaba 6EXAP 6-Channel PCM 72Mhz/ R136HP/ 4xS3003 富他巴 [6EXAP_c9]