Futaba 6EXAP 6-Channel PCM 72Mhz/ R146IP 富他巴   [6EXAP_c11]

價格:
HKD$989.58
牌子:
Futaba
型號:
6EXAP_c11
請輸入姓名和電子郵件地址。當貨品重新上架我們將笫一時間通知閣下.
你或可於 R/C Models - System - Transmitter - Flight Transmitters
類別中嘗試尋找類似的產品
填寫評論
FEATURES:
  • Aileron, Elevator and Rudder double rate switch - utilize this change to ��flip�� between two aileron, elevator and rudder control throw settings. The throws are set up however choose, but generally, when the switch is ��up�� the throws are greater (��high rate��) and when the switch is ��down�� the throws are less (��low rate��). This switch also flips between exponential rates (if used).
  • Flap control dial/Channel 6 - This dial runs the servo connected to channel 6 in receiver if for example the model has flaps this is actually the control used to use them.Aileron/elevator control stick -Mounting point for optional neck strap.
  • Trim levers (all) -Used to move the basic or center place of every servo as labeled inside diagram.
  • Recharging jack - Port for recharging the transmitter batteries utilizing the included battery charger.
  • On-off switch
  • DATA INPUT lever - always replace the values associated with the various functions shown on the LCD display screen.
  • Liquid-crystal screen (LCD) - shows programming modes and values entered.
  • MODE key - regularly scroll through and display the ten or eleven(PCM) different functions.
  • SELECT key - Used to show the values the current function.
  • Throttle-cut switch - To use the throttle-cut function, reduced the throttle stick all the way, then Push the throttle-cut key to completely close the carburetor and shut associated with the motor.
  • Throttle/rudder control stick - runs the servos connected to channel 3 (throttle) and channel 4 (rudder) inside receiver.
  • Trainer switch - Operates the trainer functions. To operate as a trainer switch the transmitter should be connected to another transmitter via. a trainer cord (available individually).
  • Retractable landing gear switch/Channel 5 - Switch runs the servo connected to channel 5 inside receiver in case the model has retractable landing gear this is actually the control used to expand and retract the gear.
  • Antenna - Radiates signals to the receiver. Never ever fly a model without fully extending the antenna or you may produce interference with other modelers and decrease functional signal selection of the transmitter. The antenna are eliminated and changed with another whenever it is inadvertently broken.

Copyright © 2013-2024 rcjaz.com.hk 版權所有